![]() You will need to edit the aliases to the controller and application ports you are using. ![]() I’ve attached a diagram of the proper setup to do this as well as an example project file. Please be sure to annotate which fader you are moving and the resultant fader movement in ATEM within the log capture so that we can adjust appropriately. Here is the project file APC-MINI-Dot2-Feedback-Example-.bmtp (2.1 KB) Note: Oh and I use the global variable gb for the flash state of the LED 1On and 0Off. last year middle relief either hold small lead keep small deficit place. Here is my Alias assignment (I’m using the second APC-MINI since I have 2 attached.). Then you can turn on logging and we can have a look. Quality Synthetic Lawn in Fawn Creek, Kansas will provide you with much more than a green turf and a means of conserving water. upgrade fair number brave soul upgraded clock oscillator share experience. What you need to do for me to be able to help is set up Bome MIDI Translator with your MIDI controller as input and the ATEM application as output (IE Bome MIDI Translator 1) and visa versa with the routing as shown below. ![]() Here's the only Mackie Control documentation I have found. Mackie Control emulation is meant so that X-Touch can be used with every music program (legacy). I’m not that familiar with ATEM capabilities but if you can monitor the MIDI messages that are being sent with your controller that moves your faders (using the logging capability of Bome MIDI Tranlsator) then we can certainly translate these messages the way you want them. The X-Touch Mini's documentation for changing LED values works as expected only for Standard Mode. I believe the ATEM OSC bridge only works on Mac. There is software you can get for your ATEM to accept OSC messages and then you can use OSCulator to translator MIDI to the OSC message of your choice (whatever the ATEM OSC bridge accepts). One thing ATEM OSC does not support is the Fairlight audio section, I found out, that ATEM supports the Mackie Controls form my XTouchmini to control the Main Fader and the pan. I’m using an Behringer Xtouch mini with ATEMOSC and Osculator to control preview, Cuts and so on. Now, if the ATEM does not allow for direct MIDI control of the faders,Īnd you are running OSCulator. Hi, in this pandemic I came into Videostreaming and I’m doing this with an ATEM Mini Pro. If the ATEM allows for direct MIDI input, and the sliders are already defined MIDI messages, then yes.įor instance if ATEM allows for Mackie MCU MIDI control of the faders, then we can use Bome MIDI Translator to translate the fader 5 mackie MCU message to the fader 1 MCU message and so forth.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |